Tutorial HUV Freezing with a Magic Switch [Un-patchable!]

[dxk]

Check out my YouTube Video of HUV Hacking :)

[Only registered and activated users can see links. ]

[Only registered and activated users can see links. ]

How To Make A Lagswitch

Step One
Take your e-thernet cord and find a spot, mainly torwards an end, find a spot and cut 2-3 inches of the insulation off, not through the cord, just the insulation around the wires inside. Now there are two wires inside you need, orange stripped and orange solid (no stripes).



Step Two
Now you will see wires inside, but find the orange set, there are two seperate them and you should have a solid orange, and a stripped orange. Take the solid orange.



Step Three
Take the solid orange wire and cut the cord in half. Now strip about an inch(1 inch) off of both ends of the solid orange wire you have cut in half. Now after you stripp the solid orange wire you will now see metal copper prons/wires.



Step Four
Now take both ends of the solid orange wires you stripped and place the copper prons/wires on the switch (light switch) such as below, now either tape, screw, glue, and etc. Make sure you have those wires places stuck there on all times, so you dont get disconnected.

Tutorial by IsoKing. If you're still having trouble, look here for a video guide:

[Only registered and activated users can see links. ]

[Only registered and activated users can see links. ]

Credits to Household Hacker for the great video guide.

Sorry if you can't understand how to make one of these...
To the other few of us, enjoy your un-patchable HUV hack :D

Remember the rep and thanks buttons